The * means it is selectedĪTTACH VDISK << if you get Access is denied the disk cannot be expanded Select VDISK FILE=E:MyPathYourFileName.vhd << This opens the VHD (full drive and path to the file are required) You can eliminate the path if it is on the root of the drive… At the DISKPART> prompt… replace the drive, path and filename of your vhd file in the command below. you can get this by doing a series of dir commands as indicated above. You will need the drive letter, path and filename of your VHD file. If you cannot mount using disk part (you get “access denied” message)Ĭommands to mount… from the command prompt You can confirm that the capacity available on disk is the problem. Using Diskpart you can (usually) mount the VHD to manipulate the contents of the VHD. Why would it be read-only? Looks like windows may mark it as read-only if a boot fails due to out of disk space? If it was not read-only, look for files on that physical drive you can delete (you may also want to have an extra USB drive plugged in so you can move the files to that USB drive instead of deleting). If there is an “R” to the left of the file, you will need to change it using the following command… Once you find the drive, make sure the VHD file is not read only using the attrib command Look for the underlying drive…Įtc… until you find the underlying drive. When you get to the first screen (asks for keyboard) press Shift-F10 to drop to a command prompt. If you have this problem, try booting to a windows 7 or windows Server 2008 DVD. If you do not have enough capacity you will get a blue screen (aka Screen of Death). When you are using Boot to VHD you must have enough capacity on the underlying disk to fully expand the VHD.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |